Skip to Content
  1. All products
  2. AUTOMATIC CYLINDERS
  3. BURG-WÄCHTER ZBK 71 CAM LOCK
  4. AUTOMATIC CYLINDERS
Pricelist: 00. Publieke prijslijst Pricelist
Pricelist: 00. Publieke prijslijst Pricelist

BURG-WÄCHTER ZBK 71 CAM LOCK

18.04 EUR 18.04

21.83 € 21.83 €

18.04 € 18.04 € excl. VAT

Stock: 0 Units
Location(s): None found

  • Outer diameter Ø (mm)
  • Inner diameter Ø (mm)
  • Inner diameter Ø (mm)
  • Distance from housing to lip (mm)
  • Type of closure
Add to cart
Add to wishlist
Contact Us
Outer diameter Ø (mm): Ø 24.6
Inner diameter Ø (mm): Ø 17.8 , Ø 20.5
Distance from housing to lip (mm): 16
Type of closure: Keyed different (KD)
Article Number: ZBK 71
Barcode: 4003482223703

CYLINDER ZBK 71 WITH TWO BOLTS: REPLACEMENT FOR LETTERBOXES FROM RENZ & DACYEUX

Your letterbox lock needs to be replaced? No problem with the right letterbox lock as an inexpensive replacement part. BURG-WÄCHTER offers separate letterbox cylinders for quick and easy self-installation.The letterbox cylinders can be used on many letterboxes of different makes without any problems. Not only from BURG-WÄCHTER.

INSTALL CYLINDER ZBK 71 IN JUST A FEW STEPS

The letterbox lock ZBK 71 is suitable for letterboxes made by Renz (up to year of manufacture 2006), Dacyeux and others. If the lock of your letterbox from one of these manufacturers needs to be replaced, the letterbox cylinder ZBK 71 is the right choice. After a few simple steps, your letterbox is ready for use again. The cylinder is supplied with two bolts. This way you can find the right bolt for your letterbox. Assembly tip: Note that the key is not removed during the assembly process.  

1. Technical data sheet for letterbox cylinder ZBK 71 from BURG-WÄCHTER: 

It is very important to maintain your lock properly, especially if it is exposed to the elements of nature a lot. Dirt and corrosion can build up, especially during cold and inclement weather. Therefore, we recommend lubricating your door lock at least twice a year or ideally at every seasonal change. 
To make sure your lock runs smoothly again, we recommend using lubricants such asWD-40 WHITE LITHIUM SPRAY GREASE. The correct use of these oils is essential.

​In general, there are two solutions for lock maintenance: prevention/protection and troubleshooting. 

If a lock is difficult to open, it could be due to two reasons: 
​
​1. The key and lock are not yet properly matched, this is common with a new lock

​​2. There is dirt build-up or rust in the lock

In these cases, we recommend using WD-40 WHITE LITHIUM SPRAY GREASE to solve the problem. This will prevent rust from forming in the lock. However, it is important that you apply the oil in the right place in the lock so that the WD-40 gets to the moving parts to ensure proper lubrication.